Premium double-shielded polyurethane cable for Geotech gauged and absolute submersible pressure transducers, cut to length in 25 ft increments. Four 24 AWG tinned copper conductors (red, white, blue, orange) plus a bare tinned drain wire, in a 0.335–0.360" polyurethane jacket.

Pick the right cable — they are not interchangeable

• Vented (gauged transducers) — carries a Nylon 6/6 vent tube that keeps the sensor referenced to atmosphere. This is what makes a gauged reading barometrically compensated at the sensor. The vent must be protected by a desiccant cartridge, aneroid bellows, or vented junction box.
• Non-vented (absolute transducers) — sealed, no vent tube, nothing to maintain. Slightly less per foot.

Fitting vented cable to an absolute sensor, or non-vented cable to a gauged sensor, will not give you a usable measurement — match the cable to the transducer you ordered.

Ordering notes

• Lengths run 25 ft to 500 ft in 25 ft steps. Need something longer, or an odd length? Contact us — we cut to order routinely, and the per-foot line is still available in Transducer Parts & Accessories.
• A cable spool is required for any run over 150 ft. Small to 350 ft, medium to 800 ft, large to 2500 ft — all in the parts collection.
• Measure from the sensor to your termination point and add slack for the wellhead and enclosure. Running short is the most common ordering mistake.
• Surge suppression is recommended anywhere with lightning exposure.

Documentation

• Submersible Pressure Transducer — installation and operation manual (PDF)
• Pressure Transducers — specifications (PDF)